Change pipe centreline type in pipe arrangement dwg

Topics related to creation of the Pipe, HVAC, Equipment, and Penetrations model in ShipConstructor including catalog definition, part definition and spooling.
Post Reply
matho
Posts: 2
Joined: Mon Apr 20, 2009 6:59 pm
ShipConstructor Experience Level: Intermediate
Location: Fremantle
Contact:

Change pipe centreline type in pipe arrangement dwg

Post by matho » Mon Apr 20, 2009 7:10 pm

G'day,
Is there a way to change the pipe centreline type from continuous to centre in a piping arrangement drawing? I've checked in the pipe drawing option but that only allows to change the colour. I'm using shipconstructor 2008
thanks

thoff
Posts: 1
Joined: Mon Mar 15, 2010 1:02 pm
ShipConstructor Experience Level: Intermediate

Re: Change pipe centreline type in pipe arrangement dwg

Post by thoff » Tue Jun 22, 2010 1:33 pm

I would also like to know if this is possible or not. It would be very helpful.

matho
Posts: 2
Joined: Mon Apr 20, 2009 6:59 pm
ShipConstructor Experience Level: Intermediate
Location: Fremantle
Contact:

Re: Change pipe centreline type in pipe arrangement dwg

Post by matho » Fri Oct 22, 2010 12:17 am

I found away to show the pipe centre line to the dash type by changing the linetype in the layer property to centre line.

thanks

check out www.one2three.com.au

Post Reply