Any workaround for Object enabler?

Topics related to the ShipConstructor Object Enabler
Post Reply
DncOfMobile
Posts: 2
Joined: Mon Dec 21, 2009 3:59 pm
ShipConstructor Experience Level: Advanced

Any workaround for Object enabler?

Post by DncOfMobile » Mon Dec 21, 2009 4:06 pm

the requested deliverable from us is a Xref type drawing that has all planar groups in one drawing (bind:insert) then e-mail this to them. they use AutoCAD LT and for some reason the enabler does not work for LT. is there a workaround or any type of export that will allow them to see the piece marks? do you plan on supporting LT versions with the SC2008 Object Enabler any time soon? and what is the reason it isn't supported?

Philip Christensen
Posts: 110
Joined: Thu Oct 09, 2008 8:42 am
ShipConstructor Experience Level: Advanced

Re: Any workaround for Object enabler?

Post by Philip Christensen » Tue Dec 22, 2009 7:53 am

An Export drawing would be the way to go. You can use a 2D view or flatshot it to work in LT
Regards
Phil

DncOfMobile
Posts: 2
Joined: Mon Dec 21, 2009 3:59 pm
ShipConstructor Experience Level: Advanced

Re: Any workaround for Object enabler?

Post by DncOfMobile » Tue Dec 22, 2009 9:23 am

I've exported a DXF but when i open it i get a incorrect DXF error. also tried Igesout and bring it back in but no luck. the only way to get what i need if through a DWF file which is useless other than for checking.

Post Reply