Page 1 of 1

Re-use deleted profile plot sheet name

Posted: Mon Oct 01, 2012 7:06 pm
by akhmad123
I have try to re-use deleted profile plot sheet name as mention in this website as follows:
Save and Re-open the profile plot drawing, but is not work, still could not be used.
I try following way and it works:
------------------------------------
1. Open particular existing profile plot drawing. Select Profile Plot List:
Nest and Profile Plots > Profile Plot > Zoom
Record sheet name listed but not shown in plot drawing (plot sheet name with out child group or no 'plus mark' on it).
2. Open PlotSheets Numbering Database:
ShipConstructor Manager > Database Utilities > Tables > STRUC > STRUCT_tblExtrutionPlotSheets
Plot Sheet name shown in 'ExtrusionPlotSheetName' column, mark 'IsDeleted' check mark box(s) for appropriate plot sheet to be deleted base on listed in point 1.
Clock 'OK' button and confirm to update database.
3. Back to particular profile plot drawing, 'Re-fresh Drawing' (Structure > Modeling Utilities > Reload Drawing).
Confirm to remove un-used sheet naming.
Save plot drawing, close and re-open.
Update all keywords: Production > Production Utilities > Update All Keywords.
Save drawing.
------------------------------------
Could you please help us for 'another way' rather than above with out access raw database as known very-risk for us?
Thanks,
Akhmad Daumawi

Re: Re-use deleted profile plot sheet name

Posted: Thu Oct 04, 2012 9:22 am
by SSI Jason Paterson
Have you tried using check profile drawings (SCPROFILEPLOTCHECK)?

Re: Re-use deleted profile plot sheet name

Posted: Thu Oct 11, 2012 4:44 pm
by akhmad123
Dear Jason,
I have tried (SCPROFILEPLOTCHECK) as mentioned, but still same.
I we run zoom (SCPROFILEPLOTCHECK) in profile plot drawing, the sheet number still on there without sub-sheet list and can't be used.
Regards,